密集型高压并联电容器
    密集型高压并联电容器
    概述 general description
      集合式高压并联电容器主要用于工频50Hz,额定电压6kv、10kv 及35kv 的电流系统中,用来提高功率因数,改善电网质量,降低线路损耗,充分发挥输变电设备效能。
      由集合式高压并联电容器和高压真空断路器或六氟化硫断路器,串联电抗器,氧化锌避雷器及放电线圈等设备组成的高压并联电容器装置,具有装置结构简单,体积小、容量大、占地省、安装使用方便的优点,产品为全户外式,从而大幅度节省了基建费用,具有良好的经济效益和社会效益。
    It is mainly used in 50Hz,rated voltage 6kv,10kv as well as 35kv system,to improve power oefficient,electric net quality and deceasing routines onsumption,exerting its functions.    High voltage shunt capacitor device is composed of congreg ating high voltage shunt and high voltage vacuum breaker or sulfur hexa fluoride breaker.In series reactor, Zinc oxide lightning arrester as well as discharging coil etc. equipments.With signplicitf of structure,small occupation,large capacity,ease of installation etc.features.it can be installed outside.so it can save a lot of con struction building exp ense. with good e conomic and social effect.

    型号说明 model meanings

    1. 单元液体介质代号F 表示单元采用苯基乙苯基乙烷(PEPE)。作为浸渍剂,A 表示苯基甲苯(M/DBT);
    2. 单元固体介质代号M 表示单元采用的固体介质为全膜介质:
    3. 相数1 为单相,3 为三相
    4. 额定电压的优先值如下:6.6/ 3,11/ 3,10.5,11,12/ 3,12……
    5. 额定容量的优先值如下:
    单相:900,1667,2500Kvar,
    三相:900,1500,1800,2400Kvar,
    6. 额定电压及额定容量也可根据用户的实际情况来确定。但35kv 等级的电容器一般做成单相,单相电容在900~2500kvar 之间;10kv 等级及以下的电容器,单相容量一般不超过2500kvar。
    1.Unit liqui dme dium code F means it adopts phenyl ethane(PEPE)as soaking agent.A means pheny 1 toluene(M/DBT);
    2.Unit soli dmedfum cbde M me ans it adopts full m em brane meditim;
    3.1 means single phase;3 means three-phase;
    4.Rated Voltage priority value is shown as following;
    5.Rated capacity priority value is shown as following;
    Single Phase:900,1667,2500Kvar;
    Three Phase:900,1500,1800,2400kvar;
    6.The rated voltage and capacity can be selected against the actual conditions.But 35kV capacitor is generally as single phase.singlg phase cap acitan ce is between900anal 2500kvar.The single phase capacity of 10kV capacitor and below 10kv is generally not more than 2500kvar.

    主要技术参数 main technical parameter
    1. 电容器的电容偏差值:-5~+10%;
    2. 电容器内部每串联组,串联段间的电容之差不大于0.5%,三相单元中在任何两个线路端子间测得的最大值电容与最小电容之比超过1.02;
    3. 在0.9~1.1Un,室温度条件下测得的电容器损耗角正切值小于0.0005;
    4. 电容器在额定电压、额定输出、环境温度50℃时,外壳温升不大于5K;
    5. 电容器采用符合标准的绝缘冷却油,从油箱下部取出的油样耐压值不小于45kv;
    6. 其它主要性能符合JB7112-2000《集合式高压并联电器》和DL/T628-1997《集合式高并联电容器订货技术条件》标准。
    1.Capacitan ce Deviatlon Value of CaPaeitot:-5~+10% ;
    2.In the interior capacitor,every in series unit,the difference of segment of cap a citor is not more than 0.5%,in threephase, the rate scale between max capacitor and mih. Capacitor from any two terminal ends is more than 1.02.
    3.Between 0.9~1.1Un,under the normal temperature,the tangent value of consuming angle of capacitor is not more than 0.0005;
    4.Under the rated voltage.rated output.environmetal
    temperature of 50℃ .its exteior temperature is not more than 15K;
    5.It adopts standar dized insul ating cooling oil,its antiprdssure value from bottom of oil tank is not more than 45 kv;
    6.Other main chara cters complies to JB7112-2000 Congregating High Voltage Parallel Connection Capacitor and the Stand ard of DL/T628-19970rder Technology Conditions of Congregating High Voltage Shunt Capacitor.

    客户订做如有尺寸要求需提供以下数据 Size of customer requirements to be made if the following data



  • 问:质量怎么样?
  • 答:我们的产品经过国家电力电容器质量监督检测中心检测合格,并且是同行业中率先通过ISO90001:20000质量体 系认证的企业。
  • 问:电容器运行中会不会发生爆炸?
  • 答:只要严格安装说明书使用,安装电容器专用熔断器,爆炸就不会发生。
  • 问:公司规模如何?
  • 答:公司创建于1996年,注册资金550万,拥有标准厂房8000余平方米。
    1.我公司生产的每台产品在出厂前都经过严格的检测,产品的质量合
    格率在99%以上,另外我们对产品保用一年,只要在一年内有质量问
    题可以包修包换包退。
    2.一般在不影响下次销售的话,可以退货。
    3.只要严格安装说明书使用,安装电容器专用熔断器,就不会发生爆
    炸等情况。